A.The originator of the TCN immediately floods this information through the network.
B.The TCN propagation is a two step process.
C.A TCN is generated and sent to the root bridge.
D.The root bridge must flood this information throughout the network.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Catalyst R is the root bridge for both VLAN 1 and VLAN 2.What is the easiest way to load-share traffic across both trunks and maintain redundancy in case a link fails，without using any type of EtherChannel link-bundling？（）
A. Increase the root bridge priority （increasing the numerical priority number） for VLAN 2 on Catalyst D so that port D2 becomes the root port on Catalyst D for VLAN 2.
B. Decrease the port priority on R2 for VLAN 2 on Catalyst R so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
C. Decrease the path cost on R2 on Catalyst R for VLAN 2 so that port D1 will be blocked for VLAN 2 and port D2 will remain blocked for VLAN 1.
D. Increase the root bridge priority （decreasing the numerical priority number） for VLAN 2 on Catalyst R so that R2 becomes the root port on Catalyst D for VLAN 2.
A.Loop guard only operates on interfaces that are considered point-to-point by the spanning tree.
B.Loop guard only operates on root ports.
C.Loop guard only operates on designated ports.
D.Loop guard only operates on edge ports.
A.It may allocate IP addresses from an unknown subnet to the users.
B.All multicast traffic can be sniffed by using the DHCP multicast capabilities.
C.The CPU utilization of the first hop router can be overloaded by exploiting DHCP relay open ports.
D.A potential man-in-the-middle attack can be used against the clients.
A. 1） lowest root bridge id，2）lowest sender bridge id，3）lowest port id，4）lowest root path cost
B. 1） lowest root path cost，2）lowest root bridge id，3）lowest sender bridge id，4）lowest sender port id
C. 1） lowest root bridge id，2）lowest sender bridge id，3）lowest root path cost 4）owest sender port id
D. 1） lowest root bridge id，2）lowest root path cost，3）lowest sender bridge id，4）lowest sender port id
A. VTP updates are ignored and forwarded out all ports.
B. VTP updates are ignored and forwarded out trunks only.
C. VTP updates are made to the VLAN database and are forwarded out trunks only.
D. VTP updates are ignored and are not forwarded.
最新試題
What is the correct command to set the router ID for an OSPFv3 process？（）
On the basis of the network provided in the exhibit， all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails， what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24， assuming that all the packets sent during convergence are transmitted once （there are no dropped or retransmitted packets）？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
In GLBP，which router will answer on client ARP requests？（）
When STP UplinkFast is enabled on a switch utilizing the default bridge priority， what will the new bridgepriority be changed to？（）
How does an IPv6 router deal with a packet that is larger than the outgoing interface MTU？（）
Which two statements are true about RED？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
In order to configure two routers as anycast RPs， which of these requirements， af a minimum， must besatisfied？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）