A.EIGRPv6 will form a neighbor relationship.
B.EIGRPv6 will not form a neighbor relationship.
C.EIGRPv6 will form a neighbor relationship， but with the log MSG： "EIGRPv6 neighbor not on a commonsub net."
D.EIGRPv6 will form a neighbor relationship， but routes learned from that neighbor will not be installed inthe routing table.
您可能感興趣的試卷
你可能感興趣的試題
A. It supports autonegotiation for both ISL and IEEE 802.1Q trunks.
B. It must be disabled on an interface if you do not want the interface to work as a trunk or start negotiation to become a trunk.
C. It is a point-to-multipoint protocol.
D. It is a point-to-point protocol.
E. It is not supported on private VLAN ports or tunneling ports.
A.link local
B.area wide
C.AS wide
D.reserved
A. 802.1D bridges do not relay BPDUs.
B. 802.1w bridges do not relay BPDUs.
C. 802.1D bridges only relay BPDUs received from the root.
D. 802.1w bridges only relay BPDUs received from the root.
A.A router solicitation is sent on that interface.
B.There is a duplicate address detection on the host interface.
C.The link local address is assigned on the host interface.
D.A neighbor redirect message is sent on the host interface.
A.It will advertise the prefix to all other client peers and non-client peers.
B.It will not advertise the prefix to EBGP peers.
C.It will only advertise the prefix to all other IBGP peers.
D.It will not advertise the prefix to any peers.
最新試題
Which two statements about SA caching are true？（）
Which protocol and port have been assigned by IANA for RADIUS authentication？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
What is the command to configure RSVP to reserve up to one-tenth of a Gigabit link，but only allow eachindividual flow to use 1 MB/s？（）
What is also called Type 0 authentication in OSPF on Cisco Routers？（）
Which multicast address is reserved for cisco-rp-discovery？（）
Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0？（）
Which two of these are used in the selection of a root bridge in a network utilizing Spanning Tree ProtocolIEEE 802.1 D？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
What is true about Unicast RPF in strict mode？（）