A. If none of the authentication servers that are configured for the current authentication mode responds to an authentication request， the DCNM-LAN server falls back to localauthentication.
B. DCNM-LAN only supports TACACS+.
C. Each DCNM-LAN server will have the same device credentials.
D. Administering DCNM-LAN authentication settings requires an authentication license.
E. DCNM-LAN server users are local to the DCNM-LAN server.
您可能感興趣的試卷
你可能感興趣的試題
A. changing the default policy map from a default MTU of 1500 to 9216
B. using the command system jumbomtu 9216
C. using the command interface MTU 9216
D. configuring the default Ethernet system class to an MTU of 9216 with a new network QoS policy map
A. two IP addresses， one for each supervisor
B. three IP addresses， one virtual IP and one physical IP for each supervisor
C. one IP address that is shared among supervisors
D. none—management 0 will use the IP address from the first SVI that is created
A. Receive port： Enabled， Transmit port： Enabled
B. Receive port： Enabled， Transmit port： Desired
C. Receive port： Enabled， Transmit port： Disabled
D. Receive port： Disabled， Transmit port： Desired
E. Receive port： Desired， Transmit port： Desired
A. NX-OS uses a random MAC address from the IEEE OUI block that is assigned to Cisco.
B. The VDC system MAC is pulled from the active supervisor and concatenated through a hash to ensure uniqueness.
C. NX-OS uses a value that is based on a range that is assigned to the SPROM of the system backplane.
D. The VDC system MAC is based on a range that is allocated to the first line card that is installed in the switch.
A. The module is powered up， and interfaces are in an "admin down" state.
B. The module is denied power， and a syslog message is generated.
C. The module is powered up， and interfaces are allocated to VDC0.
D. The module is powered up， and interfaces are allocated to VDC100.
最新試題
Refer to the exhibit. According to the equipment tab in Cisco UCS Manager， which is true？（）
What would be the cause for the following fault in UCS Manager？（） "ether VIF x / xxx down， reason： ENM source pinning failed"
When will an "all configuration" backup be imported into the Cisco UCS Manager？（）
Your company wants Server 1/eth0 （vNIC 1） configured so that it always uses Fabric Interconnect A Port Channel 1 （Po1） when it communicates with anything outside of the Cisco UCS domain. However， if vNIC 1 fails over to Fabric Interconnect B using fabric failover， then vNIC 1 can any uplink port on Fabric Interconnect B. Which statements are true？ （）
What is the use of an "all configuration" backup in Cisco UCS？（）
Which is true when describing a connection replication in Cisco ACE？（）
Which three statements are possible causes for the "fltAdaptorHostIfLink-down" fault in UCS Manager？ （）
Which statements are true regarding the Cisco UCS fabric failover feature？ （）
Which are valid statements about Cisco Virtual Interface Card （VIC）？ （）
Where are SAN Port Channel is created in UCS Manager？（）