A.highest router ID first， then highest priority
B.highest MAC address first， then highest priority
C.highest router ID first， then highest MAC address
D.highest priority first， then highest router ID
E.highest priority first， then highest MAC address
您可能感興趣的試卷
你可能感興趣的試題
A.Route tagging is one of the techniques used by RTBH
B.It is used for BGP authentication
C.It cannot work with static routes
D.It uses extended ACLs for blocking attacks by creating a black hole
E.Before configuring RTBH LDP must be enabled on the interface
A.path monitoring
B.tandem connection monitoring activation deactivation （TCM ACT）
C.Payload Structure Identifier （PSI）
D.multiframe alignment signal （MFAS）
E.section monitoring
A.The tunnel that is not configured with the policy-class command acts as the default
B.EXP selection is between multiple tunnels to the same destination
C.There is no requirement for IGP extensions
D.Tunnels are configured using the policy-class command and carry multiple EXP values
E.It supports VRF traffic， IP-to-MPLS switching， and MPLS-to-MPLS switching
A.VPI 16
B.DLCI
C.VPI and VCI
D.circuit number
E.PVC and SVC
A.never takes place
B.periodically
C.during switchover
D.after switchover
E.before switchover
最新試題
Cisco IOS XR Software Multicast Routing Implementation， which three features are supported in IPv6 onCisco CRS router？（）
Two islands of IPv6 networks that are running ISIS （IPv6 IGP） must be connected using a tunnel over anIPv4 network. Which tunneling method can be used to achieve this goal？（）
When an MPLS Layer 2 VPN runs in the hub-and-spoke model， where is QoS implemented？（）
Which four statements about Ethernet virtual circuit （EVC） infrastructure are true？ （）
Which of the following is used to periodically multicast by DIS on a LAN to ensure IS-IS link state databaseaccuracy？（）
Which three are advantages of SONET？（）
MPLS label mapping on an LSR is displayed by which IOS command？（）
Which Modular QoS CLI （MQC） based output queuing method is designed to support multiple trafficclasses including VoIP traffic， mission-critical traffic， interactive traffic， and default class traffic？（）
Which statement about VPLS is true？（）
There are two cabling schemes to choose from when implementing a Cisco CRS-1 multishelf system：single-module cabling and multimodule cabling. What is the maximum capacity of the LCCs that aresupported in multimodule cabling？（）