SW5/6為透明模式,SW1為ser模式,SW2/3/4為client模式,問:如果在SW5上添加一個VLAN,如何使全網(wǎng)學習到這個VLAN?
您可能感興趣的試卷
你可能感興趣的試題
A.Only UplinkFast and BackboneFast are specified in 802.1w;PortFast must be manually configured.
B.Only PortFast is specified in 802.1w;UplinkFast and BackboneFast must be manually configured.
C.None of the proprietary Cisco enhancements are specified in 802.1w.
D.PortFast,UplinkFast,and BackboneFast are specified in 802.1w.
A.IP ToS of 0xEF
B.IP experimental ECN
C.DSCP decimal 5
D.Binary value of 101110
A.DHCP requests will be switched in the software, which may result in lengthy response times.
B.The switch will run out of ACL hardware resources.
C.All DHCP requests will pass through the switch untested.
D.The DHCP server reply will be dropped and the client will not be able to obtain an IP address.
A.Is best suited for applications that are in the one-to-many category.
B.SSM uses shortest path trees only.
C.The use of SSM is recommended when there are many sources and it is desirable to keep the amount of mroute state in the routers in the network to a.
D.There are no RPs to worry about.
最新試題
What field in IP packet is used for classification by QOS?
what is the advantage of policing opposite to shaping?
what is four ospf area type?
Refer to the exhibit.The network administrator is in acampus building distant from Building B.WANRouter is hosting a newly installed WAN link on interface S0/0.The new link is not functioning and the administrator needs to determine if the correct cable has been attached to the S0/0 interface.How can the administrator accurately verify the correct cable type on S0/0 in the most efficient manner?()
The following configuration line was added to router R1 Access-list 101 permit ip 10.25.30.00.0.0.255 any What is the effect of this access list configuration?()
How should arouter that is being used in a Frame Relay network be configured to avoid split horizon issues from preventing routing updates?()
什么問題導致SERVER VTP密碼跟替他交換機VTP密碼不匹配?
問一個怎么樣的屬性,能讓路由不通告給任何的peer?
A network administrator is troubleshooting the OSPF configuration of routers R1 and R2.The routers cannot establish an adjacency relationship on their common Ethernet link.The graphic shows the output of the show ip ospf interface e0 command for routers R1 and R2.Based on the information in the graphic,what is the cause of this problem?()
What is method list for configure aaa?