A.Enable VTP pruning on any switch in the management domain
B.Enable VTP pruning on any client switch in the domain
C.Enable VTP pruning on a VTP server in the management domain
D.Enable VTP pruning on every switch in the domain
E.None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
A.VTP version 2 supports Token Ring VLANs
B.VTP version 2 allows VLAN consistency checks
C.VTP version 2 allows active redundant links when used with spanning tree
D.VTP version 2 reduces the amount of configuration necessary
E.VTP version 2 saves VLAN configuration memory
A.VTP mode
B.VTP password
C.VTP revision number
D.VTP pruning
E.VTP domain name
F.None of the other alternatives apply
Refer to the exhibit. VTP has been enabled on the trunk links between all switches within the TEST domain. An administrator has recently enabled VTP pruning. Port 1 on Switch 1 and port 2 on Switch 4 are assigned to VLAN 2. A broadcast is sent from the host connected to Switch 1. Where will the broadcast propagate?（）
A.Every switch in the network receives the broadcast and will forward it out all ports.
B.Every switch in the network receives the broadcast，but only Switch 4 will forward it out port 2.
C.Switches 1，2，and 4 will receive the broadcast，but only Switch 4 will forward it out port 2.
D.Only Switch 4 will receive the broadcast and will forward it out port 2.
A.30 seconds
B.5 minutes
C.1 minute
D.10 seconds
E.5 seconds
F.None of the other alternatives apply
A.A root VTP server
B.A trunk port
C.VTP priority
D.VLAN 1
E.None of the other alternatives apply
最新試題
Which two statements are true about BPDU port-guard and BPDU filtering？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
Which router redundancy protocol cannot be configured for interface tracking？（）
What two things will occur when an edge port receives a BPDU？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
What will occur when a nonedge switch port that is configured for Rapid Spanning Tree does not receive a BPDU from its neighbor for three consecutive hello time intervals？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）