A.A peer router running IBGP
B.A peer router running EBGP
C.A community member running IBGP
D.A peer group member running IBGP
E.A peer group member running EBGP
您可能感興趣的試卷
你可能感興趣的試題
A BGP router is configured as shown below：
interface ethernet 0
ip address 10.10.10.1 255.255.0.0!
int serial 0
ip address 172.16.1.1 255.255.255.252!
router bgp 65001
neighbor 192.168.1.1 remote-as 65002
Based on the above configuration， which of the following BGP statements would inject the10.10.0.0/16 prefix into the BGP routing table？（）
A.network 10.0.0.0
B.network 10.10.0.0 mask 255.255.0.0
C.network 10.10.10.1 mask 255.255.255.255
D.network 10.10.10.0 mask 255.255.255.0
E.network 10.0.0.0 mask 255.255.0.0
A.The IBGP routers must always be fully meshed
B.The IBGP routers can be in a different AS
C.The IBGP routers must be directly connected
D.The IBGP routers do not need to be directly connected
E.None of the other alternatives apply are true
The network consists of two separate autonomous systems as shown below：
You need to configure Router R2 as a BGP route reflector and Router R1 as the client. Assumingthat Router R3 isn’t running BGP， which two of the commands below would you enter on R2 tosatisfy your goals？（）
A.neighbor 165.50.12.1 remote-as 65100
B.neighbor 165.50.12.2 remote-as 64000
C.neighbor 165.50.12.1 route-reflector-client
D.neighbor 165.50.12.2 route reflector-client
Refer to the exhibit. All routers are configured for BGP. EBGP routes received on router R2 showup in the BGP table on routers R1 and R3 but not in their IP routing tables. What would causethis？（）
A.EBGP multihop is not configured on routers R1 and R3
B.Routers R1 and R3 do not receive the same routes via an IGP
C.Synchronization in autonomous system 100 is turned is on
D.The BGP routers in autonomous system 100 are not logically fully-meshed
E.Synchronization in autonomous system 100 is turned is off
A.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose2 because of the higher MED value of SanJose2
B.The serial 0/0/1 interface on the ISP router has been configured with the set metric 50command
C.The output was generated by entering the show ip bgp command on the SanJose1 router
D.The output was generated by entering the show ip bgp command on the ISP router
E.The serial 0/0/1 interface on the ISP router has been configured with the set metric 75command
F.When traffic is sent from the ISP to autonomous system 64512， the traffic will be forwarded toSanJose1 because of the lower MED value of SanJose1
最新試題
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Drag the IOS commands from the left that would be used to implement a GRE tunnel using the10.1.1.0.30 network on interface serial 0/0 to the correct target area on the right.
You need to configure a GRE tunnel on a IPSec router. When you are using the SDM to configurea GRE tunnel over IPsec， which two parameters are required when defining the tunnel interfaceinformation？（）
cisco ios command to interface dialer 0
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Drag and drop question. The upper gives the MPLS functions， the bottom describes the planes.Drag the above items to the proper location at the below
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）
Drag the DSL local loop topic on the left to the correct descriptions on the right.