A.Memory requirements are higher for shared distribution tree than for source distribution tree
B.Creates a tree from a central RP to all last-hop routers
C.Uses a rendezvous point
D.An optimal path is created between each source router and each last-hop router
E.Place （S，G） entry in each router’s multicast routing table
F.Place （*，G） entry in a router’s multicast routing to table
您可能感興趣的試卷
你可能感興趣的試題
A.Statically defined RP
B.Bootstrap Router
C.Auto-RP
D.RP Discovery Protocol （RDP）
E.RP Helios
F.RPARP（RARP）
A.it is not a valid NetFlow command
B.it is an SNMP command that exports 1500-byte packets to IP address 192.168.1.50
C.it is a NetFlov/ command that v/ill export 1500-byte packets to IP address 192.168.1.50
D.it is a NetFlov/ command that allows IP address 192.168.1.50 to send traffic to port 1500
E.It is a NetFlov/ command that v/ill specify that the NetFlov/ collector’s IP address is192.168.1.50 over UDP port 1500
F.It is an SNMP command that exports flows to destination address 1Q2.168.1.50 for packets upto an MTU of 1500
A.Following the traffic path
B.Top-down
C.Comparing configurations
D.Bottom-up
E.Divide and conquer
F.Examine SLAs
A.Extranet VPN
B.Managed overlay VPN topology
C.Hub-and-spoke VPN topology
D.Central-site VPN topology
E.Full mesh VPN topology
F.Remote-access VPN topology
A.The interface must be configured as a Multilink PPP interface
B.The correct bandwidth should be configured on the interface
C.A QoS policy must not be currently attached to the interface
D.CEF must be enabled
E.AutoQoS must be enabled globally before it can be enabled on the interface
F.An IP address must be configured on the interface if its speed is equal to or less than 768 kbps
最新試題
A new router was configured with the following commands：The configuration above was found on an Internet Service Provider’s （ISP） Multiprotocol LabelSwitching （MPLS） network. What is its purpose？（）
Router NetworkTut is configured as shown below：Given the above configuration， which statement is true？（）
Network Topology Exhibit：Configuration Exhibit：NET（config）# access-list 112 deny icmp any any echo logNET（config）# access-list 112 deny imp any any redirect logNET（config）# access-list 112 deny icmp any any mask-request logNET（config）# access-list 112 permit icmp any 10.1.1.0 0.0.0.255NET（config）# interface Fa0/1NET（config-if）# ip access-group 112 inYou work as a network administrator at networkTut.com， study the exhibit carefully. Theconfiguration has been applied to router NET to mitigate the threat of certain types of ICMPbasedattacks while allowing some ICMP traffic to the corporate LAN to work. However， the configurationis incorrect. On the basis of the information in the exhibit， which configuration option wouldcorrectly configure router NET？（）
This item contains several questions that you must answer. You can view these questions byclicking on the Questions button to the left. Changing questions can be accomplished by clickingthe numbers to the left of each question. In order to complete the questions， you will need to referto the SDM and the topology， neither of which is currently visible. To gain access to either thetopology or the SDK click on the button to left side of the screen that corresponds to the sectionyou wish to access. When you have finished viewing the topology the SDK you can return to yourquestions by clicking on the Questions button to the left.Which IPSec rule is used for the Olympia branch and what does it define？（）
Which two encapsulation methods require that an 827 ADSL router be configured with a PPPusername and CHAP password？（）
Drag the protocols that are used to distribute MPLS labels from the above to the target area on thebelow.（Not all options will be used）
Drag the DSL local loop topic on the left to the correct descriptions on the right.
Identify the recommended steps for worm attack mitigation by dragging and dropping them into thetarget area in the correct order.
cisco ios command to interface dialer 0
As a network technician， do you know what is a recommended practice for secure configurationmanagement？（）