單項選擇題

Refer to the exhibit. EIGRP is configured on all routers in the network. On a basis of the show ip eigrp topology output provided, what conclusion can be deri ved? ()

A.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out inquiring for a second successor to network 10.6.1.0/24
B.Router R1 can send traffic destined for network 10.6.1.0/24 out of interface FastEthernet0/0
C.Router R1 is waiting for a reply from the neighbor 10.1.2.1 to the hello message sent out before it declares the neighbor unreachable
D.Router R1 is waiting for a reply from the neighbor 10.1.2.1 in response to the query sent out about network 10 .6.1.0/24


您可能感興趣的試卷

你可能感興趣的試題

1.單項選擇題EIGRP has been configured to opera te over Frame Relay multipoint connections. What should the bandwidth command be set to?()

A. the CIR rate of the lowest speed connection multiplied by the number of circuits
B. the CIR rate of the lowest speed connection
C. the CIR rate of the highest s peed connection
D. the sum of all the CIRs divided by the number of connections

2.多項選擇題Which three statements about the EIGRP routing protocol are true?()

A. EIGRP supports five generic packet types, including hello, database description (DBD), link state request (LSR), link - state update (LSU), and LSAck.
B. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.10.
C. EIGRP will not form a neighbor relationship with another peer when their K values are mismatched.
D. EIGRP sends periodic hello packets to the multicast IP address 224.0.0.9.
E. E IGRP will form a neighbor relationship with another peer even when their K values are mismatched.
F. EIGRP supports five generic packet types, including hello, update, query, reply, and ACK packets.

3.單項選擇題After DUAL calculations, a router has identified a successor route, but no routes have qualified as a feasible successor. In the event that the current successor goes down, what process will EIGRP use in the selection of a new successor?()

A. EIGRP will automatically use the route with the lowest advertised distance (AD) .
B. The route will transition to the active state.
C. The route will transition to the passive state.
D. EIGRP will find the interface with the lowest MAC address.
E. EIGRP will automatically use the route with the lowest feasible distance (FD).

4.多項選擇題

Based on the exhibited output, which three statements are true?()

A. The route to 10.2.0.0/16 was redistributed into EIGRP.
B. A default route has been redistributed into the EIGRP autonomous system.
C. R1 is configured with the ip summary - address command.
D. R1 is sourcing a n external EIGRP route from Null0.
E. The router at 10.1.1.2 is configured with the ip default - network 0.0.0.0 command.
F. R1 is configured with the variance command.

5.單項選擇題

Refer to the exhibit. Router R1 is connected to networks 172.1 6.1.0 /26 and 172.16.1.64 /27. On the basis of the partial output in the exhibit, which statement is true? ()

A. Router R1 will deny the 172.16.1.0/26 route while permitting the 172.16.1.64/27 route to be advertised.
B. Router R1 will advertise both rou tes.
C. Router R1 should be reconfigured with an ACL instead of an ip prefix - list command.
D. Router R1 will deny the 172.16.1.0/27 route while permitting the 172.16.1.0/26 route to be advertised.

最新試題

Router R1 has two LAN interfaces and three serial interfaces enabled for IPv6. All the inte rfaces use link local addresses automatically generated by the router.Which of the following could be the link local address of R1's interface S0/0?()

題型:?jiǎn)雾?xiàng)選擇題

The following configura tion exists on a router on one end of an IPv6 tunnel. Which type of tunnel is created by this configuration?()interface loopback 1ip address 1.1.1.1 255.255.255.255interface tunnel 2ipv6 address 2000::1::/64tunnel source loopback 1tunnel destina tion 2.2.2.2tunnel mode ipv6ipipv6 eigrp 1

題型:?jiǎn)雾?xiàng)選擇題

Which of the following features work the same in both RIP- 2 and RIPng?()

題型:多項選擇題

A client host uses IPv4 to communicate with one ser ver and IPv6 to communicate with another.Which of the following IPv6 coexistence features is likely at work on the host?()

題型:?jiǎn)雾?xiàng)選擇題

The following line of output was gathered on Enterprise Router Ent1 using the command show ip route. Which of the following answers is most likely to be true, based on thi s output?()B 128.107.0.0 [20/10] via 11.11.11.11, 00:02:18

題型:?jiǎn)雾?xiàng)選擇題

Router R1 use s MAC address 1111.1111.1111 for its Fa0/0 interface. An engineer sees the following configuration in the output of a show running - config command. Then, the engineer issues a show ipv6 interface brief command. What global unicast IPv6 address does this c ommand display for interface tunnel 1?()interface loopback 1ip address 192.168.1.1 255.255.255.255interface tunnel 1tunnel source loopback 1tunnel destination 192.168.1.2tunnel mode ipv6ip isatapipv6 address 2000::/64 eui - 64

題型:?jiǎn)雾?xiàng)選擇題

Router R1 connects to Router R2 over an Ethernet LAN with both routers using their F0/0 interfaces. R1 learns a route from R2 using EIGRP f or IPv6. That route lists F0/0 as the outgoing interface with R2 as the next hop. The configuration excerpt shows all relevant configuration on R2's F0/0 interface. Which of the following is true about R1's route?()interface f0/0mac - address 1111.1111.1 111ipv6 address 2000::/64 eui - 64ipv6 address 2001::1/64

題型:?jiǎn)雾?xiàng)選擇題

Which of the following are true of both OSPFv2 and OSPFv3?()

題型:多項選擇題

An engineer is reviewing another engineer's sample configuration for a GRE tunnel used to pass IPv6 traffiC. The tunnel ha s not yet been configured on the router.Which of the following commands is not required for the configuration to pass IPv6 traffic?()

題型:?jiǎn)雾?xiàng)選擇題

The answers each list a tunnel method and two consecutive IPv6 address quartets.Which answers identify a tunneling method that relies on an IPv4 address to be embedded into an IPv6 address, within the correct quartets listed?()

題型:多項選擇題