LDAP is being used throughout the Company wireless network.
Which statement about the Lightweight Access Point Protocol （LWAPP） protocol is true？（）
A. The processing of 802.11 data and management protocols and access point capabilities is distributed between a lightweight access point and a centralized WLAN controller.
B. LWAPP advertises its WDS capability and participates in electing the best WDS device for the wireless LAN.
C. LWAPP aggregates radio management forward information and sends it to a wireless LAN solution engine.
D. LWAPP authenticates all access points in the subnet and establishes a secure communication channel with each of them.
E. None of the other alternatives apply
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Both host stations are part of the same subnet but are in different VLANs. On the basis of the information presented in the exhibit，
which statement is true about an attempt to ping from host to host？ （）
A. The two different hosts will need to be in the same VLAN in order for the ping command to be successful.
B. A Layer 3 device is needed for the ping command to be successful.
C. The ping command will be successful without any further configuration changes.
D. A trunk port will need to be configured on the link between Sw_A and Sw_B for the ping command to be successful.
Based on the network diagram and routing table output in the exhibit，
which of these statements is true？ （）
A. InterVLAN routing will not occur since no routing protocol has been configured.
B. InterVLAN routing has been configured properly， and the workstations have connectivity to each other.
C. Although interVLAN routing is not enabled， both workstations will have connectivity to each other.
D. Although interVLAN routing is enabled， the workstations will not have connectivity to each other.
Refer to the exhibit. VLAN2， VLAN3， and VLAN10 are configured on the switch D-SW1. Host computers are on VLAN 2 （10.1.2.0）， servers are on VLAN 3 （10.1.3.0）， and the management VLAN is on VLAN10 （10.1.10.0）. Hosts are able to ping each other but are unable to reach the servers. On the basis of the exhibited output，
which configuration solution could rectify the problem？（）
A. Assign an IP address of 10.1.3.1/24 to VLAN3.
B. Configure default gateways to IP address 10.1.10.1 on each host.
C. Enable IP routing on the switch D-SW1.
D. Configure a default route that points toward network 200.1.1.0/24.
E. Configure default gateways to IP address 10.1.2.1 on each host.
F. Configure default gateways to IP address 200.1.1.2 on each host.
Refer to the exhibit. Host A and Host B are connected to the Catalyst 3550 switch and have been assigned to their respective VLANs. The rest of the 3550 configuration is the default configuration. Host A is able to ping its default gateway， 10.10.10.1， but is unable to ping Host B. Given the output displayed in the exhibit，
which statement is true？ （）
A. A separate router is required to support interVLAN routing.
B. VTP must be configured to support interVLAN routing.
C. VLANs 10 and 15 must be created in the VLAN database mode.
D. The global config command ip routing must be configured on the SW1 switch.
E. HSRP must be configured on SW1.
F. Interface VLAN 10 must be configured on the SW1 switch.
Refer to the exhibit. Dynamic ARP inspection （DAI） is enabled on switch SW_A only. Both Host_A and Host_B acquire their IP addresses from the DHCP server connected to switch SW_A.
What would the outcome be if Host_B initiated an ARP spoof attack toward Host_A ？ （）
A. The spoof packets will be inspected at the ingress port of switch SW_A and will be permitted.
B. The spoof packets will not be inspected at the ingress port of switch SW_A and will be permitted.
C. The spoof packets will not be inspected at the ingress port of switch SW_A and will be dropped.
D. The spoof packets will be inspected at the ingress port of switch SW_A and will be dropped.
最新試題
Based on the show spanning-tree vlan 200 output shown in the exhibit， which two statements about the STP process for VLAN 200 are true？ （）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
Which router redundancy protocol cannot be configured for interface tracking？（）
Refer to the exhibit. STP has been implemented in the network. Switch SW_A is the root switch for the default VLAN. To reduce the broadcast domain， the network administrator decides to split users on the network into VLAN 2 and VLAN 10. The administrator issues the command spanning-tree vlan 2 root primary on switch SW_A. What will happen as a result of this change？（）
During routine maintenance， G1/0/1 on DS1 was shutdown. All other interface were up. DS2 became the active HSRP device for Vlan101 as desired. However， after G1/0/1 on DS1 was reactivated. DS1 did not become the active HSRP device as desired. What need to be done to make the group for Vlan101 function properly ？ （）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
DS2 has not become the active device for Vlan103’s HSRP group even though all interfaces are active. As related to Vlan103’s HSRP group. What can be done to make the group function properly ？ （）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Which two statements are true when the extended system ID feature is enabled？ （）