You have just purchased a new Cisco 3560 switch running the enhanced IOS and need configure it to be installed in a high availability network. On a 3560 EMI switch，
which three types of interfaces can be used to configure HSRP？（）
A. SVI interface
B. Access port
C. EtherChannel port channel
D. Loopback interface
E. Routed port
F. BVI interface
您可能感興趣的試卷
你可能感興趣的試題
A. QoS classified at layer 3 using IP precedence or DSCP.
B. Guaranteed rate service.
C. Implemented using FIFO queues.
D. All traffic has an equal chance of being dropped.
The Company is rolling out Cisco’s Architecture for Voice， Video and Integrated Data （AVVID）.
Which of the following choices represent the fundamental intelligent network services in Cisco’s AVVID？ （）
A. Quality of Service （QoS）
B. Intelligent platforms
C. Mobility and scalability
D. Security
E. High availability
Refer to the exhibit.
What is the effect when the switchport priority extend cos 3 command is configured on the switch port interface connected to the IP phone？（）
A. The IP phone is enabled to override with aCoS value of 3 the existing CoS marking of the PC attached to the IP phone.
B. The switch will no longer tag incoming voice packets and will extend the trust boundary to the distribution layer switch.
C. RTP will be used to negotiate aCoS value based upon bandwidth utilization on the link.
D. Effectively， the trust boundary has been moved to the PC attached to the IP phone.
E. The computer is now establishing theCoS value and has effectively become the trust boundary.
Refer to the exhibit.
Which Catalyst switch interface command would be used to cause the switch to instruct the phone to override the incoming CoS from the PC before forwarding the packet to the switch？（）
A. mls qos cos 2 override
B. switchport priority extend cos 11
C. switchport priority extend trust
D. switchport priority extend none
E. mls qos cos 2
F. switchport priority extend cos 2
You have configured voice VLANs on Catalyst switch R1.
Which two statements are true about the operation of voice VLANs on this device？ （）
A. When the voice VLAN feature is enabled， all untagged traffic is sent according to the default CoS priority of the port.
B. Enabling voice VLANs enables the switch to create multiple queues for traffic that is entering a port.
C. When voice VLANs are configured on a trunk link， UplinkFast must also be enabled.
D. Voice VLANs are configured to enable the switch to forward frames marked with the proper CoS values over separate physical links.
E. Enabling voice VLANs enables the switch to forward frames with a specific 802.1P marking.
最新試題
Refer to the exhibit. On the basis of the output of the show spanning-tree inconsistentports command， which statement about interfaces FastEthernet 0/1 and FastEthernet 0/2 is true？（）
Refer to the exhibit. LACP has been configured on Switch1 as shown. Which is the correct command set to configure LACP on Switch2？（）
Refer to the exhibit. Switch S2 contains the default configuration. Switches S1 and S3 both have had the command spanning-tree mode rapid-pvst issued on them. What will be the result？（）
Which option correctly identifies the Cisco IOS switching methods in descending order from the fastest method to the slowest method？（）
Refer to the exhibit. What does the command channel-group 1 mode desirable do？ （）
During routine maintenance， it became necessary to shutdown G1/0/1 on DS1 and DS2. All other interface were up. During this time， DS1 became the active device for Vlan104’s HSRP group. As related to Vlan104’s HSRP group. What can be done to make the group function properly ？ （）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
If G1/0/1 on DS1 is shutdown， what will be the current priority value of the Vlan105’s group on DS1 ？（）
Refer to the exhibit. Which Virtual Router Redundancy Protocol （VRRP） statement is true about the roles of the master virtual router and the backup virtual router？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）