A.Dead Peer Detection （DPD）
B.CDP
C.isakmp keepalives
D.GRE keepalive mechanism
E.The hello mechanism of the routing protocol across the IPsec tunnel
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. Which statement is true about the partial MPLS configuration that is shown？（）
A.The route-target both 100：2 command sets import and export route-targets for vrf2.
B.The route-target both 100：2 command changes a VPNv4 route to a IPv4 route.
C.The route-target import 100：1 command sets import route-targets routes specified by the route map.
D.The route-target import 100：1 command sets import route-targets for vrf2 that override the other route-target configuration.
Refer to the exhibit. Which statement is true about the configuration of split tunnels using SDM？（）
A.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed without going through the encrypted tunnel.
B.Any protected subnets that are entered represent subnets at the end user’s site that will be accessed through the encrypted tunnel.
C.Any protected subnets that are entered represent subnets at the VPN server site that will be accessed without going through the encrypted tunnel.
D.Any protected subnets that are entered represent subnets at the VPN server site that will be accessedthrough the encrypted tunnel.
A.All passwords entered during the AutoSecure configuration must be a minimum of 8 characters in length.
B.Cisco123 would be a valid password for both the enable password and the enable secret commands.
C.The auto secure command can be used to secure the router login as well as the NTP and SSH protocols.
D.For an interactive full session of AutoSecure， the auto secure login command should be used.
E.If the SSH server was configured， the 1024 bit RSA keys are generated after the auto secure commandis enabled.
Refer to the exhibit.
What does the "26" in the first two hop outputs indicate？（）
A.the outer label used to determine the next hop
B.the IPv4 label for the destination network
C.the IPv4 label for the forwarding router
D.the IPv4 label for the destination router
A.If the VPN server is configured for Xauth， the VPN client waits for a username / password challenge.
B.The Cisco Easy VPN feature only supports transform sets that provide authentication and encryption.
C.The VPN client initiates aggressive mode （AM） if a pre-shared key is used for authentication during the IKE phase 1 process.
D.The VPN client verifies a server username/password challenge by using a AAA authentication server that supports TACACS+ or RADIUS.
E.The VPN server can only be enabled on Cisco PIX Firewalls and Cisco VPN 3000 series concentrators.
F.When connecting with a VPN client，the VPN server must be configured for ISAKMP group 1，2 or 5.
最新試題
Which two statements are true about broadband cable （HFC） systems？（）
Which three statements are true when configuring Cisco IOS Firewall features using the SDM？ （）
Refer to the exhibit， which shows a PPPoA diagram and partial SOHO77 configuration.Which command needs to be applied to the SOHO77 to complete the configuration？（）
Which three statements about the Cisco Easy VPN feature are true？（）
Which statement describes the Authentication Proxy feature？（）
Refer to the exhibit. Which order correctly identifies the steps to provision a cable modem to connect to a headend as defined by the DOCSIS standard？（）
Which three statements about IOS Firewall configurations are true？（）
During the Easy VPN Remote connection process，which phase involves pushing the IP address， Domain Name System （DNS），and split tunnel attributes to the client？（）
Which statement is true when ICMP echo and echo-reply are disabled on edge devices？（）
Refer to the exhibit.What does the "26" in the first two hop outputs indicate？（）