Study the exhibit shown below carefully.
In this scenario the service provider wants to ensure that switch S1 is the root switch for its own network and the network of .
On which interfaces should root guard be configured to ensure that this happens？（）
A.Interfaces 11 and 12
B.Interfaces 1， 2， 3， and 4
C.Interfaces 5 and 6
D.Interfaces 5， 6， 7， and 8
E.Interfaces 1 and 2
F.Interfaces 1， 3， 5， and 6
您可能感興趣的試卷
你可能感興趣的試題
In order to enhance worker productivity， a Cisco wireless network has been implemented at all locations.
Which three statements regarding WLAN are true？（）
A.A WLAN client will operate in half-duplex mode.
B.The Aironet 1230 access point is an example of an access point that operates solely as a lightweight access point.
C.Ad hoc mode allows mobile clients to connect directly without an intermediate AP.
D.WLANs are designed to share the medium and can easily handle an increased demand of channel contention.
E.A lightweight AP receives control and configuration from a WLAN controller to which it is associated.
F.Another term for infrastructure mode is independent service set （IBSS）.
Switch 1 was configured as shown below：
Based on the output shown above，
which statement is true？ （）
A.IP traffic matching access list is forwarded through VLANs 5-10.
B.All VLAN traffic in VLANs 5-10 that match access list will be forwarded， and all else will be dropped.
C.IP traffic matching VLAN list 5-10 will be forwarded， and all other traffic will be dropped.
D.All VLAN traffic matching VLAN list 5-10 will be forwarded， and all traffic matching access list is dropped.
E.None of the other alternatives apply
A. QoS
B. call setup and teardown
C. call routing
D. call supervision
E. audio signal compression
A. device PoE requirements
B. device IP address
C. device voice VLAN ID
D. device platform
A. an edge port that transitions to the forwarding state
B. a non-edge port that transitions to the blocking state
C. a non-edge port that transitions to the forwarding state
D. an edge port that transitions to the blocking state
E. any port that transitions to the blocking state
F. any port that transitions to the forwarding state
最新試題
What is the configured priority value of the Vlan105’s group on DS2 ？（）
What must be the same to make multiple switches part of the same Multiple Spanning Tree （MST）？（）
How are STP timers and state transitions affected when a topology change occurs in an STP environment？（）
Refer to the exhibit and the partial configuration of switch SW_A and SW_B. STP is configured on all switches in the network. SW_B receives this error message on the console port：00：06：34： %CDP-4-DUPLEX_MISMATCH： duplex mismatch discovered on FastEthernet0/5 （not half duplex）， with SW_A FastEthernet0/4 （half duplex） ， with TBA05071417（Cat6K-B） 0/4 （half duplex）. What would be the possible outcome of the problem？（）
Refer to the exhibit. Based on the output of the show spanning-tree command， which statement is true？ （）
Which router redundancy protocol cannot be configured for interface tracking？（）
Examine the diagram. A network administrator has recently installed the above switched network using 3550s and would like to control the selection of the root bridge.Which switch should theadministrator configure as the root bridge and which configuration command must theadministrator enter to accomplish this？（）
Refer to the exhibit. The command switchport mode access is issued on interface FastEthernet0/13 on switch CAT1. What will be the result？（）
Refer to the exhibit. Initially， LinkA is connected and forwarding traffic. A new LinkB is then attached between SwitchA and HubA. Which two statements are true about the possible result of attaching the second link？（）
Which three statements are true of the Link Aggregation Control Protocol （LACP）？（）