A. When a router receives a failure response, it stops querying authentication methods.
B. When a router receives an error response, it stops querying authentication methods.
C. If the router receives a failure response from an authentication method, it queries the next method.
D. The router does not differentiate between failure and error responses; the authentication process is always interrupted.
E. If it receives no response from the authentication method, a router will determine the error condition on its own; the router also has the option to proceed to the next method in a list if configured accordingly.
您可能感興趣的試卷
你可能感興趣的試題
Refer to the exhibit. MPLS has been enabled on router PE11. Which of these statements is correct regarding the output display shown in the exhibit? （）
A. CEF switching is not needed for MPLS operation.
B. CEF switching is only needed to forward labeled packets.
C. CEF switching is needed on both ingress and egress interfaces on which MPLS is enabled.
D. Interface-level CEF switching is needed only on egress interfaces that are sending IP packets on which the egress LSR performs the label imposition process.
E. Interface-level CEF switching is needed only on ingress interfaces that are receiving IP packets on which the ingress LSR performs the label imposition process.
A. syslog logging
B. terminal logging
C. buffered logging
D. console logging
A. Change Management
B. Security Assessment
C. Operations Assessment
D. Security Administration
E. Operations Readiness Assessment
F. Technology Assessment
Refer to the exhibit. A display of class maps for a configuration is shown in the exhibit. What will the class-map "all-traffic" match? （）
A. all voice traffic
B. all traffic with dscp 18 or dscp 43
C. all traffic with dscp 18 and dscp 43
D. all traffic with ip precedence 0 or 1
E. all traffic with ip precedence 4 and 5
A. Prepare, Plan, Create, Implement, Operate, and Improve
B. Prepare, Plan, Design, Implement, Operate, and Optimize
C. Prepare, Plan, Design, Apply, Operate, and Manage
D. Prepare, Plan, Design, Implement, Operate and Manage
最新試題
Which configuration will enable OSPF for IPv6 on FastEthernet 0/0/0?（）
Referring to the partial Cisco Catalyst switch configuration shown, which two of these statements are correct? （）(Choose two.)
Refer to the exhibit. You have a non-Cisco switch that is not communicating properly while connected to the distribution-layer Cisco switching fabric.Which two best-practice actions can you take to overcome this problem? （）(Choose two.)
Which of the following allows network administrators to easily apply common services and employ features across Cisco switches, routers, and access points with an intuitive GUI?（）
Which three of these items are IPv6 transition mechanisms? （）(Choose three.)
What is the most likely reason that an IBGP route that has been selected as a best route is not entered into the IP routing table?（）
Refer to the exhibit. For the given configuration, on packets leaving the router on interface FastEthernet0/0 that matches the high traffic class, what will the MPLS experimental bit be set to?（）
What is the function of the no switchport catalyst switch interface configuration command?（）
Which Cisco IOS command is used to troubleshoot a problem in which a BGP session stays in the active state?（）
As an experienced network engineer, you are asked to troubleshoot a CIS network outage. During the troubleshooting process, you notice that one of your colleagues connects additional devices to the network with the use of his own switch. With the purpose of improving speed, the switch is attached to both network ports in an office, which leads to bridge loop.Enabling which of the following feature will be able to prevent this problem from happening again?（）