A.problem management
B.configuration management
C.incident management
D.change management
您可能感興趣的試卷
你可能感興趣的試題
A.technology assessment
B.operations assessment
C.security assessment
D.security administration
E.change management
A.15
B.10
C.1
D.5
A mobility group is created by a cisco wlcm and 4402 series wireless lan controller. A client that is anchored on the cisco wlcm roams to an access point on the 4402 controller. you then run a debug command on the 4402 controller.
Which message would best describe the establishment of the tunnel from the foreign controller’s perspective？（）
A.received mobile anchor export message
B.transmit plumbing duplex mobility tunnel message
C.received plumbing duplex mobility tunnel message
D.transmit mobile anchor export message
You are charged with implementing a secure wireless installation which will provide internet
access to client devices but will not allow communications between wireless clients.
In addition to implementing pspf or peer-to-peer blocking on the wireless side，which of the following actions should you perform on the wired infrastructure？（）
A.implement a cisco secure ips sensor.
B.implement 802.1x on the switch ports.
C.take no action， you have achieved your goal.
D.implement a protected port on the access switches.
You want to dynamically assign users to an 802.1q vlan as a result of their authentication.
In order to accomplish this，which two ietf radius attributes should you configure on the cisco secure acs？（）
A.083 tunnel-preference
B.066 tunnel-client-endpoint
C.064 tunnel-type
D.082 tunnel-assignment-id
E.081 tunnel-private-group-id
F.067 tunnel-server-endpoint
最新試題
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference？（）
Which of the following parameter sets must be configured on the Cisco Wireless Location Appliance？（）
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
You are using ADU and are authenticated and associated to an access point. However， you are unable to obtain an IP address.Which of these has caused this problem？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
On a Cisco Aironet 802.11 a/b/g wireless LAN client adapter，the status LED and activity LED are alternating on and off.What does this indicate？（）
When configuring a WLAN controller for a voice application using Cisco 7920 wireless IP phones，which two general control settings should you select？（）
You have a very few Cisco 7920 wireless IP phones on your network， but lots of wireless laptops.You want to increase the bandwidth available for the laptops by decreasing the bandwidth reserved for the Cisco 7920 phones.What is the lowest percentage of voice-allocated bandwidthyou can select on the WLAN controller？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）