A.ipx
B.ip
C.udp
D.tcp
您可能感興趣的試卷
你可能感興趣的試題
A.14
B.15
C.17
D.16
A.location appliance
B.controller-based access points
C.wireless clients
D.wireless control system
E.wireless controllers
A.48
B.36
C.12
D.24
A.10
B.5
C.15
D.20
A.project planning
B.configuration management
C.wireless readiness assessment
D.systems acceptance testing
E.site readiness specification
最新試題
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton, you should verify that the file name is which of the following?()
You are troubleshooting a problem with a Cisco 7920 wireless IP phone that is causing the phoneto drop calls. The problem appears to be roaming bandwidth issue. In order to verify what kind ofissue it is, you decide to increase the bandwidth reserve for roaming on the WLAN controller tomaximum.What level do you set the bandwidth to?()
The Cisco Wireless Location Appliance provides an audit trail for each device tracked for up to how many days?()
You have been called upon to add location-based services into an existing controller-basedwireless design which primarily encompasses handheld devices such as barcode scanners and Cisco7920 wireless IP phones.In which mode should you deploy the additional access points to achievethe density required without excessive co-channel interference?()
How many WLANs can a Cisco Aironet 1242 in H-REAP mode support when actively connected toa wireless controller?()
An REAP was supporting 16 WLANs, but now it only supports one.What happened to cause the change?()
You are installing a Cisco 4402 Series Wireless LAN Controller.What type of interface is used on the uplink port?()
On a WLAN controller, what is the default roaming bandwidth percentage reserved for voice clients?()
You are installing a Cisco Aironet 1000 Series controller-based access point. When you boot it, allthe LEDs on the access point blink together.What does this indicate about the access point?()
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS? ()