A.Signal strength (4th access point)
B.Signal strength (3rd access point)
C.Channel interference
D.Predictive physical data rate downlink (2nd access point)
您可能感興趣的試卷
你可能感興趣的試題
A.Crowd of people
B.Office window
C.Metal door
D.Brick wall
A.The backhaul link is dynamic 1 to 54Mb/s.
B.The backhaul link is typically a fixed value.
C.The backhaul link uses DAS antennas.
D.The backhaul link uses antenna multiplexing.
E.The backhaul link does not rely on fade margin.
A.Transmit only
B.Diversity
C.Receive only
D.Single isolated antenna
A.LOS modulation
B.Multipath distortion
C.RF signal absorption
D.RF signal attenuation
E.Fresnel zone impedance
A.Add a new 802.11a WLAN
B.Increase the Layer 2 and Layer 3 security of the WLAN
C.Increase the throughput for the wireless clients
D.Add new services (such as voice) over the WLAN
最新試題
Which statement regarding the site-survey process is correct?()
How should the transmit power on an access point and client each be set during a site survey?()
Which three colors are used in the Cisco WCS v5.2 Voice Readiness Tool?()
Which format can NOT be imported into Cisco WCS Planning Tool?()
What is the minimum recommended access point overlap for voice roaming?()
According to the following statement, can you tell me which term is described?()It is the air return for an air conditioned system. In most buildings, the area above a drop ceiling orunder a raised floor is used as the air return (source of air) for the air conditioning. Those dropceiling and raised floors are also where wire is often installed. If wire and cable is installed in a dropceiling or raised floor, it is out of sight. If that cable were burning, it would give off toxic fumes.These would be fed to the rest of the building by the air conditioner. As a result, people could beinjured even though they are a long way from the fire.
What will cause wireless voice devices to perform poorly?()
What does a broad-spectrum interferer lower?()
Which statement about active and passive surveys is incorrect?()
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920, 7921G, and7925G?()