A.225 ft
B.450 ft
C.655 ft
D.900 ft
您可能感興趣的試卷
你可能感興趣的試題
A.OSNR
B.dispersion
C.light skew
D.attenuation
A. Each fiber has half of its SONET capacity reserved for protection.
B. Two fibers in the span carry working traffic, while the other two fibers in the span are reserved for protection.
C. The signal is sent simultaneously in both directions around the ring. The receiver determines which fiber to listen to based on signal quality.
D. The signal is sent simultaneously in both directions around the ring. The transmitter determines which fiber has the working bit set for the receiver to acknowledge.
A. prevent the leakage of external fiber emissions
B. provide the optical network with the highest level of security possible
C. assure an even distribution of 1's and 0's for extended transmitter life
D. assure an adequate number of transitions for clock recovery at the receiver
E. prevent the receiver from assuming AIS inadvertently when all 0's are received
A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).
A. amplifier
B. attenuator
C. regenerator
D. light emitter
E. optical switch
F. optical receiver
G. fiber-optic cable
Click the Exhibit button. What is the maximum allowable loss budget between the ONS 15216 Mux (left side) composite output and the ONS 15216 Demux (right side) composite input, with the optical values given in the exhibit? （）(Assume the worst case loss of 4.5 dB for 15216 200 GHz Mux/Demux and ignore power penalties or extra margin.)
A.15dB
B.17dB
C.21dB
D.26dB
E.27dB
A. The glass core is doped with an Erbium in periodic segments of the fiber.
B. Layers of high index ?and low index ?material are deposited on a glass substrate.
C. Thin layers of silica glass are placed onto wafers to produce a prism-like effect.
D. Fiber is etched with an ultraviolet laser that is precisely spaced for specific wavelength filtering.
A. DS-1; E1
B. DS-1; STM-1
C. OC-3; STM-1
D. STS-1; STM-1
E. OC-192; STM-192
A. none
B. -600 ps/nm
C. -200 ps/nm
D. +200 ps/nm
E. +600 ps/nm
A. Traffic is switched from the first node receiving the AIS indication.
B. Traffic is switched from the far side of the failure, allowing handshaking to occur.
C. UPSR traffic is switched from the terminating node, BLSR traffic is rerouted from the originating node in the ring.
D. UPSR traffic is switched from the terminating node, circuit by circuit. BLSR traffic is rerouted from the last reachable node in the ring.
最新試題
Which is a legitimate bandwidth matched pair?（）
UPSR protection switching is initiated by （）, while BLSR is initiated by （）.
How is UPSR and BLSR traffic rerouted during a protection switch when a complete fiber cable cut occurs?（）
For lasers with tightly controlled wavelengths, approximately how far apart are the centers of adjacent wavelengths when 100 GHz spacing is used in a DWDM system?（）
Why are the 1300 nm and 1550 nm regions of the fiber spectrum primarily used for optical communications?（）
What are two important considerations when using 2- or 4-channel 15216 OADMs?（） (Choose two.)
If the power is 0 dBm, what is the power in mW?（）
What three in combination are factors that can cause four-wave mixing in fiber-optic cables? （）(Choose three.)
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm, then what is the accumulated dispersion of an ITU wavelength after it travels 200 km?（）
The dispersion of a non-zero dispersion shifted fiber is 6 ps/nm*km at 1550 nm and 10 ps/nm*km at 1610 nm. What is the minimum dispersion compensation required if an L-Band DWDM signal travels through 200 km of fiber and has a dispersion tolerance of 1800 ps/nm?（）