A. They are both regions of lowest loss.
B. They are both regions of low reflections.
C. They are both regions of low index of refraction.
D. They are both regions of low chromatic dispersion.
E. They are both regions of low Polarization Mode Dispersion (PMD).
您可能感興趣的試卷
你可能感興趣的試題
A. lower cost
B. higher chirp
C. easier to manufacture
D. higher dispersion tolerance
E. higher optical signal-to-noise ratio
A. OSNR
B. dispersion
C. attenuation
D. power budget
E. amplifier spacing
F. four wave mixing
A. PIN photodiodes
B. zero-chirped lasers
C. Erbium-doped fiber amplifiers
D. dispersion compensating fiber
E. dispersion compensating Bragg grating
A.OSNR
B.dispersion
C.light skew
D.attenuation
A.none
B.one
C.two
D.three
E.four
最新試題
Scrambling of SONET signals is done to ().
What are three relevant design considerations when using the 15216 EDFA? ()(Choose three.)
What is the phenomenon called where different wavelengths of light travel at different speeds?()
SONET Code Violations (CVs) totals in the PM tables are actually an accumulation of the number of ().
What three in combination are factors that can cause four-wave mixing in fiber-optic cables? ()(Choose three.)
What is the difference between the transmitted power and the sensitivity of the receiver?()
UPSR protection switching is initiated by (), while BLSR is initiated by ().
If the dispersion of a given fiber is 17ps/nm*km at 1550 nm and zero at 1310 nm, then what is the accumulated dispersion of an ITU wavelength after it travels 200 km?()
If node 2 is accepting line timing from node 1, node 2 will send ()to node 1 as its SSM message.
How is a Thin Film filter fabricated?()