A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information
您可能感興趣的試卷
你可能感興趣的試題
A. An IPv4-compatible tunnel is a static tunnel， but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers， but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains， but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel， the ISP assigns only IPv4 addresses for each domain， but for a 6to4 tunnel， the ISP assigns only IPv6 addresses for each domain.
A.configure a hard-to-guess VTP domain name
B.use a hard-to-guess VTP password
C.use VTP transparent mode
D.implement VTP version 3
A. prefixes received from any other BGP peer and prefixes locally originated via networkstatements or redistributed to BGP
B. all prefixes in its IP routing table
C. only prefixes received from EBGP peers and prefixes locally originated via network statements or redistributed
D. only prefixes received from EBGP peers and prefixes received from route reflectors
E. all prefixes in its routing table except the prefixes received from other EBGP peers
F. all prefixes in its routing table except the prefixes received from other IBGP peers
A.excessive collisions
B.FCS errors
C.runts
D.late collisions
A.interface gig3/1 spanning-tree guard root
B.interface gig3/1 spanning-tree root guard
C.interface gig3/1 spanning-tree root-guard
D.interface gig3/1 spanning-tree root-guard default
最新試題
Which of these best describes the actions taken when a VTP message is received on a switch configuredwith the VTP mode "transparent"？（）
Which types of prefixes will a router running BGP most likely advertise to an IBGP peer， assuming it is notconfigured as a route reflector？（）
In GLBP，which router will answer on client ARP requests？（）
In Layer 2 topologies， spanning-tree failures can cause loops in the network. These unblocked loops cancause network failures because of excessive traffic. Which two Catalyst 6500 features can be used to limitexcessive traffic during spanning-tree loop conditions？（）
An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each，terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs，and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem？（）
Which two are differences between IGMPv2 and IGMPv3 reports？（）
In PIM-SM what control plane signaling must a multicast source perform before it begins to send multicasttraffic to a group？（）
Based on the exhibit presented. What will be the objective of this route map when applied to traffic passing through a router？（）
Choose two commands that are required to enable multicast on a router， when it is known that thereceivers use a specific functionality of IGMPv3.（）
The classic Spanning Tree Protocol （802.1 D 1998） uses which sequence of variables to determine thebest received BPDU？（）