多項選擇題Which two IPv6 address pairs can be assigned on a point-to-point link with a /125 mask?()

A.2001:DB8::1 and 2001:DB8::2
B.2001:DB8::9 and 2001:DB8::10
C.2001:DB8::10 and 2001:DB8::17
D.2001:DB8::1 and 2001:DB8::18


您可能感興趣的試卷

你可能感興趣的試題

1.多項選擇題Which three causes could prevent a host from getting an IPv6 address with stateless autoconfiguration?()

A.The autoconfig command is missing from the router interface.
B.IPv6 multicast routing is not enabled on the router interface.
C.IPv6 unicast routing is not enabled on the router interface.
D.The router interface is configured with a /63 mask.
E.The router interface is configured with a /65 mask.

2.單項選擇題Which IPv6 address would you ping to determine if OSPFv3 is able to send and receive unicast packets across a link? ()

A. anycast address
B. site-local multicast
C. global address of the link
D. unique local address
E. link-local address

3.多項選擇題Which two combinations are valid PAgP configurations that will set up a PAgP channel?()

A.On-Passive
B.On-Auto
C.Passive-Active
D.Desirable-Auto
E.Active-Active
F.Desirable-Desirable

4.單項選擇題Which information is carried in an OSPFv3 intra-area-prefix LSA? ()

A. IPv6 prefixes
B. link-local addresses
C. solicited node multicast addresses
D. IPv6 prefixes and topology information

5.單項選擇題Which of these statements best describes the major difference between an IPv4-compatible tunnel and a 6to4 tunnel? ()

A. An IPv4-compatible tunnel is a static tunnel, but an 6to4 tunnel is a semiautomatic tunnel.
B. The deployment of a IPv4-compatible tunnel requires a special code on the edge routers, but a 6to4 tunnel does not require any special code.
C. An IPv4-compatible tunnel is typically used only between two IPv6 domains, but a 6to4 tunnel is used to connect to connect two or more IPv6 domains.
D. For an IPv4-compatible tunnel, the ISP assigns only IPv4 addresses for each domain, but for a 6to4 tunnel, the ISP assigns only IPv6 addresses for each domain.

最新試題

Which two statements are true about RED?()

題型:多項選擇題

Which command is used to enable SSM with the range 232.0.0.0 - 255.0.0.0?()

題型:單項選擇題

Which two are differences between IGMPv2 and IGMPv3 reports?()

題型:多項選擇題

Which three options are valid ways to filter routes from a BGP peer?()

題型:多項選擇題

Which two statements about SA caching are true?()

題型:多項選擇題

On the basis of the network provided in the exhibit, all routers are configured to run EIGRP on all links. If the link between PG-R1 and PG-R2 fails, what is the maximum number of queries PG-R3 will receive for 192.168.1.0/24, assuming that all the packets sent during convergence are transmitted once (there are no dropped or retransmitted packets)?()

題型:單項選擇題

Spanning Tree Protocol IEEE 802.1 s defines the ability to deploy which of these?()

題型:單項選擇題

Which message type is constructed and sent from an MSDP router to its MSDP peers when it receives a PIM register message knowing that the MSDP router is also configured as an RP for the PIM domain?()

題型:單項選擇題

You are the network administrator of an enterprise with a main site and multiple remote sites. Your networkcarries both VOIP and data traffic. You agree with your service provider to classify VOIP and data trafficaccording to the different service RFCs. How can your data and VOIP traffic be marked?()

題型:單項選擇題

An expanding company is deploying leased lines between its main site and two remote sites. Thebandwidth of the leased lines is 128kb/s each,terminated on different serial interfaces on the main router.These links are used for combined VOIP and data traffic. The network administrator has implemented a VOIP solution to reduce costs,and has therefore reserved sufficient bandwidth in a low latency queue oneach interface for the VOIP traffic. Users now complain about bad voice quality although no drops areobserved in the low latency queue. What action will likely fix this problem?()

題型:單項選擇題