A.data/coverage
B.location with Monitor Mode access points
C.demand
D.high density
您可能感興趣的試卷
你可能感興趣的試題
A.100 mW， 24 Mb/s
B.100 mW， 18 Mb/s
C.25 mW， 18 Mb/s
D.3.2 mW， 54 Mb/s
A.In a multifloor building， the access point layout from the survey of one floor can be directly applied to the remaining floors
B.Access points can be installed in the same place on every floor， without worrying about co-channelinterference
C.You can survey with a Cisco AIR-ANT5959 in a plenum environment
D.Identify all hazardous and restricted areas that might require extra or special survey and installationwork
A.Active mode does not require the client to be specifically confgured
B.Passive mode can survey more than one access point at a time
C.Active mode yields signal-quality information such as packet retries and lost packets
D.Active mode requires more time to survey but yields more information results than passive mode does
A.20 percent cell overlap
B.four access points detecting a client at -76 dBm or better
C.10 percent cell overlap
D.three access points detecting a client at -75 dBm or better
A.at 30mW
B.matched to the antenna gain
C.differing by at least 20 dBi
D.matched to each other
最新試題
What is a site survey best practice for location-based services？（）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
After the site installation is complete， you should verify the mobility of the VoWLAN device whilewalking the site on an active phone call. Which Cisco WLC or Cisco WCS command is mostbeneficial in determining roaming efficiency？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
In which three frequency bands does the Cisco Spectrum Expert Wi-Fi tool perform spectrumanalysis？ （）
Which class of Cisco access points operate under IEEE 802.3af power？（）
What will cause wireless voice devices to perform poorly？（）
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However， whenusing a long Ethernet cable， the device can draw up to how much additional wattage？（）
Which three colors are used in the Cisco WCS v5.2 Voice Readiness Tool？（）
Which three items does the Cisco WCS Planning Tool Generate Proposal Report provide？（）