A.3
B.1
C.4
D.6
您可能感興趣的試卷
你可能感興趣的試題
A.psk authentication
B.eap authentication
C.wpa authentication
D.web authentication
Vlans have been enabled on an autonomous access point. in order for clients associating to vlans other than the native vlan to receive an ip address.
Which of the following must be configured？（）
A.access point ethernet port set to ssl trunking
B.switchport set to 802.1q trunking
C.switchport set to ssl trunking
D.access point ethernet port not set to 802.1q trunking
A.controller name
B.outdoor area
C.floor area
D.networks
E.mac address
F.ip address
A.router （config）# wlccp authentication-server infrastructure eap group_1
B.router （config）# wlccp authentication-server infrastructure eap-fast group_1
C.router （config）# wlccp authentication-server client eap-fast group_1
D.router （config）# wlccp authentication-server client eap group_1
A.registration error
B.authentication failures threshold
C.http disabled
D.telnet disabled
最新試題
A mobility group is created by a Cisco WLCM and 4402 Series Wireless LAN Controller. A client thatis anchored on the Cisco WLCM roams to an access point on the 4402 controller. You then run adebug command on the 4402 controller.Which message would best describe the establishment ofthe tunnel from the foreign controller’s perspective？（）
The IOS of a North American Cisco Aironet 1130AG Series standalone access point has becomecorrupt. You must therefore reload the TFTP firmware.Before you press and hold the MODEbutton， you should verify that the file name is which of the following？（）
You want to dynamically assign users to an 802.1Q VLAN as a result of their authentication. Inorder to accomplish this.Which two IETF RADIUS attributes should you configure on the CiscoSecure ACS？ （）
You are charges with implementing a secure wireless installation which will provide Internet accessto client devices but will not allow communications between wireless clients.In addition to implementing PSPF or peer-to-peer blocking on the wireless side，which of the following actionsshould you perform on the wired infrastructure？（）
When configuring Cisco Secure ACS to support wireless EAP authentication， which device must be configured as a AAA client？（）
On a Cisco Aironet 1240AG Series standalone access point， the radio LED is dark blue and blinking，but the status LED and Ethernet LED are both off.What does this indicate？（）
Which protocol does the RADIUS server use inside the secure tunnel of EAP-FAST to authenticatethe client when one-time passwords are in use？（）
An REAP was supporting 16 WLANs， but now it only supports one.What happened to cause the change？（）
If it is properly deployed， a controller-based access point is capable of monitoring all VLANs on anetwork when you select which of the following modes from the AP Mode drop-down menu onthe controller？（）
Static WEP is configured on the access point. You are authenticated and associated to the accesspoint but are unable to obtain an IP address.Which of the following will cause this problem？（）