A.Add a new 802.11a WLAN
B.Increase the Layer 2 and Layer 3 security of the WLAN
C.Increase the throughput for the wireless clients
D.Add new services （such as voice） over the WLAN
您可能感興趣的試卷
你可能感興趣的試題
A.Identify potential problem areas
B.Define intended coverage areas
C.Access compliance with local building codes
D.Determine the final location of APs and antennas
E.Identify sources of RF signal attenuation and RF interference
A.Implementation suggestions
B.Access point locations
C.Security requirements
D.Access point mounting methods
A.Access point received-signal strength level
B.Spectrum utilization
C.Client data rate
D.In-band radio frequency interference
A.300
B.448
C.664
D.1800
E.2400
最新試題
When planning for VoWLAN capacity during a site survey， how many simultaneous calls can beestimated per 5 GHz channel？（）
The Cisco Aironet 1140 Series Access Point draws 12.95 W at the power source. However， whenusing a long Ethernet cable， the device can draw up to how much additional wattage？（）
Which can NOT be selected for supported services in Cisco WCS Planning Tool？（）
When using a lightning arrestor， connect which type of ground wire to a good earth ground？（）
When planning for voice deployments with the Cisco Unified Wireless IP Phone 7921G handset in amultifloor building with a WLAN that operates at an 11 MB/s data rate， how many decibelsreferenced to 1 milliwatt of same-channel separation are recommended between floors？（）
For an active Cisco Unified Wireless IP Phone 7921G 5 GHz site survey， what are the mostappropriate client test settings to use with the AirMagnet site survey tool？（）
Cisco recommends a decibel referenced to 1 milliwatt signal level for the coverage cell edge at thepredetermined data rate that is needed to support the VoWLAN device and call capacityrequirements. What is that signal level value for Cisco Unified Wireless IP Phones 7920， 7921G， and7925G？（）
In an outdoor bridge link， what is calculated by using this formula： transmitter power + antennagain - insertion OR cable loss（）？
Given the correct input parameters， the Cisco WCS Planning Tool can calculate a recommendedaccess point count for which three uses？ （）
When conducting a wireless voice site survey， which two sizing considerations exist for thecoverage cell？（）